Rigid-flex DFA
September 19, 2023 | Andy Shaughnessy, Design007Estimated reading time: 1 minute
Rigid-flex assembly brings its own set of issues, but designers can do quite a bit to make things easier on their downstream brethren. We asked IPC instructor Kris Moyer to give us the lowdown on DFA for rigid-flex circuitry.
Kris, what are some of the unique challenges related to assembling rigid-flex circuits?
There are several challenges to assembly of rigid-flex boards. First there is the alignment issue of the different sections of the boards. With a rigid board, the individual boards can be removed from the fabrication panel and run through the SMT assembly line without much problem, as long as the board is of sufficient size. In this case, the relative position of all the individual parts on the board remains consistent. But with rigid-flex, after the board is removed from the fabrication panel, the individual boards can move and rotate relative to each other within the limits of the flex material. This makes the placement of parts difficult to control. To overcome this, the board must be held in a restrained condition throughout the assembly process. This will require either the fabrication of a custom fixture to hold the board restrained during assembly or the design of temporary removable restraining mechanisms (rails) into the design of the board.
To read this entire conversation, which appeared in the September 2023 issue of Design007 Magazine, click here.
Suggested Items
Real Time with… IPC APEX EXPO 2024: Tools, Training, and Trends in Manufacturing Engineering
04/25/2024 | Real Time with...IPC APEX EXPOGuest Editor Kelly Dack and Product Specialist Erik Bateham of Polar Instruments discuss Polar's latest technology, including their role in aiding manufacturing engineers. They highlight the advanced capabilities of Polar's tools and the critical role of signal integrity analysis, as well as the importance of accurate modeling in board manufacturing. Polar's unique training approach and demonstration contact details are also explored.
Determining the Value-add of Box Build
04/24/2024 | Nolan Johnson, I-Connect007At a strategic level, adding box-building services makes sense for customer loyalty. But is it really that simple? Jon Schmitz, who manages customer engagement at RiverSide Integrated Solutions, talk about about what it really takes to be successful in offering EMS and final assembly services under the same company banner.
Designer’s Notebook: What Designers Need to Know About Manufacturing, Part 2
04/24/2024 | Vern Solberg -- Column: Designer's NotebookThe printed circuit board (PCB) is the primary base element for providing the interconnect platform for mounting and electrically joining electronic components. When assessing PCB design complexity, first consider the component area and board area ratio. If the surface area for the component interface is restricted, it may justify adopting multilayer or multilayer sequential buildup (SBU) PCB fabrication to enable a more efficient sub-surface circuit interconnect.
LPKF Extends Contract of CEO Klaus Fiedler until 2028
04/24/2024 | LPKFThe Supervisory Board of LPKF Laser & Electronics SE has decided to extend the contract of Dr. Klaus Fiedler as CEO until 31 December 2028. "Under the leadership of Klaus Fiedler, LPKF has undergone some extensive transformation since he joined just over 2 years ago.
IPC Design Competition Champion Crowned at IPC APEX EXPO 2024
04/24/2024 | IPCAt IPC APEX EXPO 2024 in Anaheim, California, five competitors squared off to determine who was the best of the best at PCB design.