Successful Flex Circuit Design and Processing Guidelines


Reading time ( words)

With the use of sensors and technology in everything from mobile phones to refrigerators, automobiles, and wearable medical devices, circuit boards are a component in many different types of products. In today’s world of electronics, any product with an on-off switch contains a circuit board.

Due to their versatility, the use of flex circuits is one of the fastest growing product market segments. With the introduction of flex and rigid-flex circuits, engineers have been given the opportunity to be more creative in designing new and innovative products. Flex and rigid-flex boards are built to fit into tight, threedimensional spaces while ensuring resistance to mechanical wear and vibration. Engineers can design products that require boards to fit into tight spaces, twist and turn for packaging, and make the product live in a more dynamic environment. These flexible circuits have the same performance levels as traditional rigid FR-4 boards; however, they have their own nuances and considerations when it comes to design, fabrication, and assembly.

Design and Layout

When designing a flex circuit, it is important to know the specific application for the circuit. Will it be used in a static or dynamic environment? If the board will reside in a static environment with little to no movement, the circuit design needs to have the appropriate amount of flexibility so that it can be easily installed within the product. Alternatively, if the board will exist in a dynamic environment where the board will continuously flex back and forth, a level of flexibility that can withstand continuous movement needs to be considered in the design.

Will the application require a flex or a rigidflex circuit? If the product requires one-sided surface-mount technology, then a fully flexible board may be the best option. If the product requires two-sided SMT, then a rigid-flex board is needed.

To read the full version of this article which originally appeared in the October 2018 issue of Flex007 Magazine, click here.

Share

Print


Suggested Items

Simulation Technology in Acid Copper Pattern Plating

07/17/2020 | Pete Starkey, I-Connect007
PCB designers and CAM engineers may feel there is little they can do to achieve uniform finished copper thickness of PCB traces and holes. But in an illuminating discussion with Robrecht Belis, manager of surface finishing and e-coating with Elsyca NV in Belgium, Pete Starkey learned that nothing could be further from the truth, provided they act on time and use the right tools.

3D Additive Electronics Manufacturing: Are We Nearing an Inflection Point?

05/28/2020 | Dan Feinberg, I-Connect007
Recently, Dan Feinberg was invited to attend a detailed and broadly informative webinar by nScrypt titled “The Strength of 3D-Printed Electronics," which covered the status and advances in the use of 3D printing for electronic device design and manufacture. nScrypt is an Orlando-based company founded in 2002 that focuses on 3D printing. Here’s what Dan learned from each of the speakers.

Institute of Circuit Technology Spring Seminar 2020

03/11/2020 | Pete Starkey, I-Connect007
Back to Meriden, the nominal centre of England where the daffodils were blooming. A good crowd made it to the spring seminar that followed the Annual General Meeting of the Institute of Circuit Technology (ICT), with five specialist presentations and excellent opportunities to network with their peers in the industry. Pete Starkey shares his overview of the event.



Copyright © 2020 I-Connect007. All rights reserved.