Reading time ( words)
Donald Monn, Midwest regional sales manager for Taiyo America, turns the tables on I-Connect007 Technical Editor Pete Starkey and quizzes him about his knowledge of Taiyo's new crack-resistant white solder mask for automotive, and the company's standard photoimageables re-formulated for laser direct imaging (LDI) that avoid the need for UL requalification.
To watch the interview, click here.
Share
PrintSuggested Items
Solder Mask Tack Dry
11/08/2019 |
Nikolaus Schubkegel
As a general rule, the tack-dry temperature should be as low as possible; in other words, it should only be as high as necessary. If the temperature is too low, the evaporation rate for the solvent will be to slow, and the solder mask will not dry in a reasonable amount of time. If the temperature is too high, however, the dry time certainly will be excellent, but it could create a solder mask lock-in with repercussions by the developing time.
Communication, Part 4: The Top 5 Causes of Engineering Delays
10/25/2019 |
Steve Williams, The Right Approach Consulting LLC
In Part 4 of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits address the top five causes of engineer delays.
New High-speed 3D Surface Imaging Technology in Electronics Manufacturing Applications
10/09/2019 |
Juha Saily, Focalspec Inc.
Line confocal sensors—and scanners based on them—are used in the imaging of surfaces, transparent materials, and multi-layered structures in various metrology and inspection applications on discrete parts, assemblies, webs, and other continuous products. Line confocal sensors operate at high speed and can be used to scan fast-moving surfaces in real-time as well as stationary product samples in the laboratory.
