Lenthor Engineering Approved by Lockheed


Reading time ( words)

Lenthor Engineering, a California-based designer, manufacturer and assembler of flex and rigid-flex printed circuit boards (PCBs), has recently gained approval for their 53,000 sqft advanced flex and rigid-flex fabrication and assembly facility by Lockheed Martin Corp. (LMCO).

With this approval, Lenthor will be able to support both LMCO directly and all of their sub-contractors in the fulfillment of their high-priority defense contracts.

Share

Print


Suggested Items

Electronics Additive Manufacturing for Defense and Space

10/27/2020 | Nolan Johnson, I-Connect007
At the SMTA Additive Electronics TechXchange, Dr. Kourtney Wright spoke about Lockheed’s DoD work and explained why Lockheed is interested in additive. Nolan Johnson shares the highlights.

Laserssel Brings High-speed Soldering to New Application Areas

06/10/2019 | Barry Matties, I-Connect007
In this interview with I-Connect007, Denis Barbini, general manager of Laserssel, talks about the company's new laser-selective reflow solution aimed at reducing a typical reflow oven’s 10-minute cycle down to just 10 seconds as well as the overall benefits manufacturers could see from streamlining this process.

Flex Circuit Supply Chain Challenges

02/13/2019 | Stephen Las Marias, I-Connect007
In our recent Flex and Rigid-Flex survey, we asked the following question: "Do you have problems with your flex circuit supply chain?" Below are just a few of the explanations of those who answered "Yes", slightly edited for clarity.



Copyright © 2021 I-Connect007. All rights reserved.