FKN Systek's N100 Nibbler Available with Three Blade Types


Reading time ( words)

Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Three blade types are available in standard thicknesses of 0.120 in, 0.093 in and 0.062 in.

Custom sizes to match the width of the routed section can be ground on request. Tabs up to 0.324” (8.23 mm) are cut cleanly on each side so that no further clean-up is required to remove excess material, as is often the case when using hand tools or when breaking the panels manually. In addition, since only one tab is cut at a time, minimal stress is imparted to the board during the process as the panel is not pressed between two points during the cut.

The N100 is provided with a quick-connect pneumatic port which plugs directly into factory air (80-100 PSI). Stepping on a foot pedal activates the cutting process. The excess material from the tab is stored inside a compartment of the tool and can be easily removed at the convenience of the operator. To see a video of the N100 and other depaneling methods go to fknsystek.com.

The Sharp Blade support dies of the N100 provide a clean shearing action, ideal for singulating one tab at a time on flex circuit boards. This is the perfect tool for low volume singulation of a variety of flex circuit and standard PCBs built on a rectangular pattern.

Come by booth 107 at SMTAI Rosemont, September 24 and 25 to see FKN Systek Depaneling tools. Bring samples for evaluation.

Share

Print


Suggested Items

American Standard Circuits' Ken Moffat on Flex and Rigid-flex Business

04/22/2019 | Patty Goldman, I-Connect007
Ken Moffat is the director of business development at American Standard Circuits, where covers a fairly broad territory from his base in Toronto throughout Canada and parts of the U.S. from east to west. In an interview with I-Connect007 at the recent West Penn SMTA Expo, Ken talks about the state of the flex and rigid-flex industry.

Staying Current on Flex Manufacturing is Smart Business

04/04/2019 | Barry Matties, I-Connect007
Brendan Hogan, managing director of smart electronics manufacturer MivaTek Global, discusses how to better design for flex, and ways designers can stay current on manufacturing technology that can impact their flex boards.

TTM on Flex and Rigid-flex PCB Challenges

03/20/2019 | Barry Matties, I-Connect007
One of the biggest bareboard manufacturers in the world, TTM Technologies has seen a recent surge in flex and rigid-flex demands from their customers. In this interview, Clay Zha, Vice President of Technology Solutions of TTM’s Mobility business unit, and VP of Corporate Marketing Winnie Ng discuss the differences in manufacturing flex versus traditional PCBs, and the increasing need for rigid-flex HDI boards.



Copyright © 2019 I-Connect007. All rights reserved.