NCAB Group Seminar on Challenges of Miniaturization's Densification for PCBs


Reading time ( words)

The NCAB Group will be holding a free seminar about the challenges of the miniaturization’s densification for PCBs. The seminar will be held on November 13, 2019, from 1:30–4:30 p.m., at the NCAB Benelux office in Den Bosch, Het Sterrenbeeld 42.

Among the topics for discussion are HDI design rules to help on density; rigid-flex for more components and better reliability; and DFM (design for manufacture) improvements.

The seminar will be in English.

Share

Print


Suggested Items

Communication, Part 4: The Top 5 Causes of Engineering Delays

10/25/2019 | Steve Williams, The Right Approach Consulting LLC
In Part 4 of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits address the top five causes of engineer delays.

Communication, Part 3: Why Do Board Shops Ask So Many Questions?

10/18/2019 | Steve Williams, The Right Approach Consulting LLC
In Part 3, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits speak with Steve Williams about the importance of preparing, sending, and receiving comprehensive (and ideally, perfectly complete) design data packages. If you’ve ever wondered why the CAM department asks you so many questions, read on.

Happy Holden Previews His AltiumLive Frankfurt Keynote

10/17/2019 | Andy Shaughnessy, I-Connect007
I recently sat down for an interview with Happy Holden, who is slated to give a keynote speech at this year’s AltiumLive event in Frankfurt, Germany. Happy gives a preview of his presentation, which is focused on smart factories and automation, and why artificial intelligence might improve PCB design and fabrication in the future.



Copyright © 2019 I-Connect007. All rights reserved.