Flexible Circuit Design Guidelines


Reading time ( words)

Flexible circuit designs share many of the same challenges of rigid PCB designs, but there are also many differences and additional challenges. The very nature of a flex circuit being able to bend and flex make it as much a mechanical device as an electrical one. This creates a special set of requirements unique to flexible circuitry. Understanding how these requirements interact will allow the PCB designer to create a flex circuit that balances the electrical and mechanical features into a reliable, cost-effective interconnect solution.

Overview
Scrutinize your design for stress concentration features. Stress concentration features are the single predominant cause for mechanical failures in flexible circuits (i.e., cracked/broken conductors, torn insulating material, etc.). To avoid stress concentration points, the construction of the circuit should not change in, or immediately adjacent to, the bend area. In a bend area, there should be no change of conductor width or thickness or direction, no termination of plating or coatings, no openings in covers or outer insulating materials, and no holes of any kind in a bend zone.

Bend Ratio
Determine and evaluate the minimum bend ratio of your design. This will be your single best indicator of whether your flex circuit may experience problems in service. Bend ratio is bend radius: circuit thickness.

To read this entire article, which appeared in the January 2020 issue of Design007 Magazine, click here.

Share




Suggested Items

Ventec’s Book on Thermal Management: The Summer Sequel You’ve Been Waiting For

06/24/2022 | I-Connect007
I-Connect007 is excited to announce the release of the second title in Ventec’s series on thermal management, "The Printed Circuit Designer’s Guide to… Thermal Management with Insulated Metal Substrates, Volume 2." This second volume covers the latest developments in the field of thermal management, particularly in insulated metal substrates, using state-of-the-art products as examples, and focusing on specific solutions and enhanced properties of IMS.

PCB Plating Still Comes Down to Physics

06/21/2022 | I-Connect007 Editorial Team
We asked columnist Michael Carano to discuss the latest innovations in plating equipment and chemicals, as well as some of the drivers in this segment, and the biggest challenges and opportunities he sees in plating today. As Michael points out, despite all of the technological advances in this industry, process engineers still need a solid understanding of Faraday’s Law and Ohm’s Law to successfully plate PCBs.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

05/13/2022 | Nolan Johnson, I-Connect007
The big news in the industry this week was the new bill introduced to the U.S. Congress in support of the PCB manufacturing industry. The Supporting American Printed Circuit Boards Act of 2022, which was introduced by Reps. Anna Eshoo (D-CA) and Blake Moore (R-UT), incentivizes “purchases of domestically produced PCBs as well as industry investments in factories, equipment, workforce training, and research and development.” The bill is a PCB-oriented complement to the semiconductor-oriented CHIPS Act of 2021.



Copyright © 2022 I-Connect007. All rights reserved.